Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01 Slide 01

SHREE ELECTRONICS

"USEFUL TECHNICAL INFORMATION OF DRIVES"

Comparison Between LRS, Soft Starters and VFD

Type
  LRS Startor
      Soft Startor
      VFD
  Maintanence High Maintanance required Low Maintanance required Low Maintanance Reqired
    Low Skill required Like any Electrician Medium skill required like trend electrician High Skill required like Engineer
         
  Starting Current  3 times roughly of motor FLR  3 times roughly of motor FLR  1.2 times roughly of motor FLR
         
  Starting Time No Control 10 to 100 sec 10 to 9999 sec programmable
         
  Energy Saving Heavy energy loss Very small energy saving Heavy Energy Saving
        (IF YOU can use drive some time for low speed operation then energy saving will be very high)
  Power factor Poor as per motor nameplate Poor as per motor nameplate 0.9 Power factor
         
  No of start stop per hour limited to motor may be 4 to 5 maximum 6 start / hour No limit can give 20 or 30 start per
        hour.
  Motor Protections General MPR dependent General MPR dependent High Class semiconductor and microprocessor biased protections for Voltage , Current  and Thermal protection.
         
  Speed regulation Not possible to vary the motor speed Not possible to vary the motor speed Can control the motor speed from 0 rpm to rated rated, means 0 to 100% speed variation is possible.
         
         
  Control room interface only hard wire only hard wire Both hard wire and communication interface possible with PLC / DCS System.

Image 02

Stats Of Hits